bigog_68
12-30-2008, 08:47 PM
Van, Anyone,
How do I go about making a new poppet seal. I need a new seal really bad. Also what are the oring numbers for the MQ valve bodies?
thanks for any info
Update: I found the actual info on what the seals are and sizes
Replacement Parts
This is a list of the more commonly available replacement parts. Note that a special punch is needed to make the poppet seal.
Orings on 11/16" Valve Body 11/16"od x 1/16" -015 70 duro buna Obtain from hardware or auto parts store
Oring on Front of Standard Valve Body 1/2od x 1/16" -012 70 dura buna Obtain from hardware or auto parts store
Oring Between Pilot and Valve Body 1/2od x 1/16" -012 70 duro buna Obtain from hardware or auto parts store
Poppet Reciprocating Seal 3/8od x 1/16" -010 70 duro buna Obtain from hardware or auto parts store
Oring on Outside of Standard Valve Body (see above) 5/8od x 1/16" -014 70 duro buna Obtain from hardware or auto parts store
Poppet Face Seal 1/16" thick 90 duro urethane Punch from urethane sheet
Urethane Dot (end of solenoid plunger) 3/16dia x 1/16" 90 duro urethane Punch from urethane sheet and superglue in place
How do you punch seals out of these sheets? Who has the ablility to make poppet seals if they need a special punch?
How do I go about making a new poppet seal. I need a new seal really bad. Also what are the oring numbers for the MQ valve bodies?
thanks for any info
Update: I found the actual info on what the seals are and sizes
Replacement Parts
This is a list of the more commonly available replacement parts. Note that a special punch is needed to make the poppet seal.
Orings on 11/16" Valve Body 11/16"od x 1/16" -015 70 duro buna Obtain from hardware or auto parts store
Oring on Front of Standard Valve Body 1/2od x 1/16" -012 70 dura buna Obtain from hardware or auto parts store
Oring Between Pilot and Valve Body 1/2od x 1/16" -012 70 duro buna Obtain from hardware or auto parts store
Poppet Reciprocating Seal 3/8od x 1/16" -010 70 duro buna Obtain from hardware or auto parts store
Oring on Outside of Standard Valve Body (see above) 5/8od x 1/16" -014 70 duro buna Obtain from hardware or auto parts store
Poppet Face Seal 1/16" thick 90 duro urethane Punch from urethane sheet
Urethane Dot (end of solenoid plunger) 3/16dia x 1/16" 90 duro urethane Punch from urethane sheet and superglue in place
How do you punch seals out of these sheets? Who has the ablility to make poppet seals if they need a special punch?