View Full Version : Adjusting trigger travel on AKA hinge

12-11-2006, 07:44 PM
Hi fellas,

Glad to see most of the gang found their way here from air-powered!

I have a Revenge V2 LE with AKA hinge.

I want to know if there are trigger stops in this setup that allow trigger travel reduction.

I don't have the marker in front of me since I'm at work right now, and quite frankly it shoots so well that I have never really broken down the trigger area and looked at the inside of the frame to check.

Any help?



12-11-2006, 08:21 PM
I am sure someone here knows, but if not try the following:

Not sure on those frames. I would start by looking on the trigger itself. Any set screws on the surface of the trigger? If not then remove the grips and see if there are any set screws or holes that a set screw could be in. The wgp and system x have set screw directly below the back of the sear that restricts sear movement, which in return restricts trigger movement.
Good luck and let us know what you find out.

12-11-2006, 09:09 PM
Take the grips off and you'll see the adjustment screw.