PDA

View Full Version : internal



AlexH
03-25-2008, 02:40 AM
what parts go where?lol. im a sniper newb. i have the parts i just dont know how to install them?

AlexH
03-26-2008, 02:17 AM
no one can guide me...

T18CAPT
03-26-2008, 02:29 AM
What are you asking?

pummel u
03-26-2008, 02:39 AM
I thought there were some written articles but I cant seem to find them. The "how an autococker works" diagram in the articles section should help map things out also.

Lower tube: this is from front to back and in order
- valve spring
- cup seal and valve body
- jam nut
- hammer
- hammer spring
- ivg
-cocking rod into hammer

I suggest stacking the first three components on the valve tool and sliding them up into the body, then screwing the jam nut in place. You may need to line up the valve hole with the retaining screw hole before final tightening. Dont forget the valve retaining screw that goes up under the body to seat into the hole in the valve body, either side of the valve works.

The pump kit will screw into the banjo bolt hole in the front where the front block would sit. Then thread on the back block, put in your cocking rod and IVG.

AlexH
03-26-2008, 03:15 AM
sounds good. i think i know what i have to do. thanks.

T18CAPT
03-26-2008, 12:47 PM
http://www.pumpenstein.com/wordpress/?p=39

This may help for installation

AlexH
03-26-2008, 10:03 PM
i can do that part. i just need the stuff in the lower tube.

k.macocker
03-27-2008, 01:32 AM
hope this helps..
Kmac

http://www.pbase.com/k_macocker/image/83189648.jpg

http://www.pbase.com/k_macocker/image/83189649.jpg

AlexH
03-27-2008, 02:18 AM
wow. that helps a whol lot. thanks alot. i didnt really know what each part looked like. thanks.

k.macocker
03-27-2008, 03:26 AM
the cocking rod goes throught a dialer type rear velocity adjuster in those pics. the standard one looks like a huge brass or stainless set screw..
kmac


http://www.pbase.com/k_macocker/image/72538778.jpg

AlexH
04-05-2008, 06:57 PM
does everything go in from the back of the gun?

pummel u
04-05-2008, 07:26 PM
Yes indeedy

AlexH
04-05-2008, 07:33 PM
that helps alot lol. i was trying to get stuff throught th front of the gun rotfl

no wonder it wouldent fit :p