PDA

View Full Version : press fit feed neck


dave88ia
05-14-2008, 10:42 PM
hey van i was wondering sine u had to put in the press in threaded neck on ur mid blocks, i was wondering if u had any
Vantrepes
05-15-2008, 10:02 AM
Some, but they are raw, and they need to be milled to clear the upper tube. It's not a "crush and go" type of project.
dave88ia
05-15-2008, 08:40 PM
yea thats alright... the person i send my body to do sum work on prolly will be able to mill the rest off... how much would u want for 1?
dave88ia
05-20-2008, 08:22 AM
nvm i found 1
matt3
06-13-2008, 02:49 PM
Hey Van I had a question to tag onto this thread. I have the taiwan freeflow lotus body with the press fit feed neck :(. What is the best way to get that to stay in? should I sand the neck and apply some type of glue? What do you suggest?

Thanks

Matt
Vantrepes
06-14-2008, 09:17 AM
Red loctite works pretty well, just use enough of it. I have also used JB Weld in the past, which worked well, just be careful not have any ooze into the lower tube if you don't have a reamer to clean it out.
A set screw in the sight rail and tube don't hurt either.