Forum: Moody Paintball Products

Van, Anyone, How do I go about making a new poppet seal. I need a new seal really bad. Also what are the oring numbers for the MQ valve bodies?...

I tried to order some MQ2 parts and you were out. Any idea when you'll be getting more in? Also, i saw that you can get rams with the magnetic band...

OK, so I have a few Free Flow bodies without feed tubes, and without back blocks, so I picked up a bunch of mid block parts, and I'm going to mid...

If you have a sketch of a cocker body, or even a rough idea for one, post it here, and I'll see what I can do. I have been trying to come up with a...

Hey vant, after looking through this thread again, kmac said you ran freeflow out of business. just wondering what the story is behind this?

nathan, I realize that this might be better left to a pm but I thought this would catch your attention more. I ordered a standard mq2 valve kit...

One thing I have noticed about my tech articles is that I take a lot of basic cocker know how for granted. I have been trying to write a "Beginners...

Excuse me Mr. Vantrepes. I saw another thread where a guy asked if you could install his MQ2. If i sent you my ASR and MQ2, would you be able to time...

hey van i was wondering sine u had to put in the press in threaded neck on ur mid blocks, i was wondering if u had any

besides e2 and zerob boards. what other boards will work with the mq2. will stock ego boards work, such as the 05 ego board? list of boards please

Have an idea for an article you would like to see? Post it here.

Hey, I was just wondering if you happened to have a spring for the poppet on the original (silver) MQ valve. Thanks.

i am in need of your help with these sheared wires, to solder the wire back what do i need to do. if you could tell me step by step, do i need to...

Hey Van, I've got a bunch of questions regarding the MQ valve. Do you service the original PBX MQ valve? Is there a "trade in" program to...