Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: AKA Trigger Plate Question

  1. #11
    JB Weld does seem like the way to go. Also, thanks for the insight on the Pre-98 Trigger plate. I had specifically ordered (the only available option) on AKA which was listed as a "98 and newer trigger plate) and ran into the slack issue. As a side note, I had the chance of shooting a completely built and timed 2017 SFL and I must say, I need to spend more time with my buddies gunfighter frame...Danny Loves' sent that thing off feeling like a dream.

  2. #12

    Slow and graduate pressure on the actuator rod-end with a vice, will flatten it enough to nearly eliminate any slack.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts